BAS EN 61347-1/A1:2022

IEC 61347-1:2015+A1:2017 specifies general and safety requirements for lamp controlgear for use on d.c. supplies up to 250 V and/or a.c. supplies up to 1 000 V at 50 Hz or 60 Hz. This third edition cancels and replaces the second edition published in 2007, Amendment 1:2010 and Amendment 2:2012. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition:<br /> a) additional marking requirements;<br /> b) additional requirements for creepage distances and clearances:<br /> - for working voltages with operating frequencies up to 30 kHz;<br /> - for working voltages with higher operating frequencies than 30 kHz;<br /> - for impulse and resonance voltages ignition;<br /> - for basic, supplementary and reinforced insulation;<br /> - for insulation between circuits;<br /> - for coated or potted controlgear;<br /> c) modification of definition of ELV and FELV;<br /> d) modification of schematic drawing, showing the different controlgear classification and insulation requirements;<br /> e) scope extension;<br /> f) new Annex A: test to establish whether a conductive part is a live part which may cause an electric shock;<br /> g) new Annex M: creepage distances and clearances for controlgear where a higher degree of availability (impulse withstand category III) may be requested;<br /> h) new Annex Q: example for Up calculation;<br /> i) new Annex P: creepage distances and clearances and distance through isolation (DTI) for lamp controlgear which are protected against pollution by the use of coating or potting;<br /> j) new Annex R: concept of creepage distances and clearances.<br /> This publication is to be read in conjunction with the IEC 61347-2 series. <strong>This consolidated version consists of the third edition (2015) and its amendment 1 (2017). Therefore, no need to order amendment in addition to this publication.</strong>