The Institute for Standardization of Bosnia and Herzegovina, through its Technical Committee BAS/TC 17, Technical drawing, symbols and units, has adopted the following standards by the translation method:

BAS EN ISO 128-1, Technical products documentation (TPD) - General principles of representation - Part 1 - Introduction and fundamental requirements (EN ISO 128-1: 2020, ISO 128-1:2020)

BiH standard BAS EN ISO 128-1, Technical products documentation (TPD) - General principles of representation - Part 1 - Introduction and fundamental requirements, first edition, is a translation of an European version of EN ISO 128-1, Technical products documentation (TPD) - General principles of representation - Part 1 - Introduction and fundamental requirements.

This document gives general rules for the execution of technical drawings (2D and 3D), as well as presenting the structure of the other parts of the ISO 128 series. This document is applicable to technical drawing in the fields of mechanical engineering, construction, architecture and shipbuilding. It is applicable to both manual and computer-based technical drawings.

BAS EN ISO 128-2, Technical products documentation (TPD) - General principles of representation - Part 2 - Basic conventions for lines (EN ISO 128-2: 2020, ISO 128-2:2020)

BiH standard BAS EN ISO 128-2 Technical products documentation (TPD) - General principles of representation - Part 2 - Basic conventions for lines (EN ISO 128-2: 2020, ISO 128-2:2020), first edition, is a translation of an European version of EN ISO 128-2:2020, Technical products documentation (TPD) - General principles of representation - Part 2: Basic conventions for lines.

This document establishes the types of lines used in technical drawings (e.g. diagrams, plans or maps), their designations and their configurations, as well as general rules for the drawing of lines. In addition, this document specifies general rules for the representation of leader and reference lines and their components as well as for the arrangement of instructions on or at leader lines in technical documents. Annexes have been provided for specific information on mechanical, construction and shipbuilding technical drawings.

The original text of international standards ISO 128-1: 2020 and ISO 128-2: 2020 has been prepared by the Technical Committee CEN/SS F01, Technical drawings, the secretariat of which is held by CCMC (CEN-CENELEC Management Center).