prBAS EN 1253-7:2024
Odvodi za građevine - Dio 7: Zarobljeni podni slivnici s mehaničkim zatvaračem
Opšte informacije
Status:Projekt
Broj stranica:33
Metoda usvajanja:Proglašavanje
Jezik:engleski
Izdanje:1.
Datum realizacije:23.10.2023
Predviđeni datum naredne faze:06.03.2024
Tehnički komitet:BAS/TC 7, Okolina
ICS:
91.140.80, Odvodni sistemi
Apstrakt
This document classifies floor gullies for domestic waste water for use inside buildings, gives guidance for places of installation and specifies requirements for the construction, design, performance and marking of factory made gullies for buildings, irrespective of the material, for use in drainage systems requiring a trap with a mechanical closure (referred to as floor gullies).
NOTE Floor gullies with a depth of water seal less than 50 mm are not covered by EN 1253-1, EN 1253-7 and EN 1253-8.
These products are intended to be installed where both conditions below are fulfilled:
- the building does not exceed a ground-floor and three floors above;
- infrequent use could result in a water seal evaporating.
Životni ciklus
...
Izvorni dokument i stepen usklađenosti
EN 1253-7:2022, identičan
Radni materijal
Samo članovi tehničkog komiteta imaju pristup radnom materijalu. Ukoliko ste član, molimo prijavite se sa vašim nalogom i dobićete pristup dokumentima. Prijavite se